Table of Contents
Advertisement
To use a third-party card reader with the system, connect it to the device's USB port.
Refer to the magnetic card reader's documentation for additional information.
NOTE:
Do not connect a magnetic card reader if the barcode reader option (BCRD) is
enabled. If the BCRD option is enabled, the system expects a barcode reader and
the magnetic card reader does not function correctly.
Connecting the Barcode Reader
If you purchased the optional barcode reader, connect it to the USB port on the device.
Refer to the barcode reader's documentation for additional information.
NOTE:
The BCRD option, which must be enabled in the system in order to use the reader,
is activated at the factory when the barcode reader is purchased with the system.
You must configure the barcode settings for the site before using the reader. Refer
to
"Patient Setup" on page
Connecting the Optional Internal Modem
If the system was purchased with the internal modem option, connect the modem
to an analog phone line using the RJ11 connector on the rear of the device. See
"Rear View" on page 29
Connecting to a LAN
If you purchased the LANC (LAN Communication to CardioSoft) or LANM (LAN
Communication to MUSE) options, connect an ethernet cable to the RJ45
network connector on the back of the device. See the LAN Option Installation and
Troubleshooting Guide for information on configuring the LAN connection.
If you purchased the WIFC (WiFi Communication to CardioSoft) or WIFM (WiFi
Communication to MUSE) options, connect the WiFi module on the USB port on the
back of the device. See the LAN Option Installation and Troubleshooting Guide for
information on configuring the WiFi connection.
NOTE:
If you are using this device as a mobile device, do not connect it to a LAN until you
are ready to import, transmit, or export records.
Connecting an External Laser Printer
You can use this system with an external USB laser printer connected to its USB port
or a network printer connected to its LAN connection. You must use the printer away
from the patient vicinity and it must:
• Be compliant with IEC60950 or equivalent standards
• Be compliant with the PCL5e language or higher
• Be compliant with the PJL language or higher (only the network printer)
• Have a minimum of 600 dpi resolution
• Have a minimum of 8 MB of memory
2060026-001C
109.
for details.
MAC™ 800
Equipment Overview
37
Advertisement
Table of Contents
