Built-In Smartport Macros - Cisco 300 Series Administration Manual

Smartport

Built-in Smartport Macros

STEP 3
STEP 4
Built-in Smartport Macros
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
• Persistent Status—Select to enable the Persistent status. If enabled, the
association of a Smartport type to an interface remains even if the interface
goes down, or the device is rebooted. Persistent is applicable only if the
Smartport Application of the interface is Auto Smartport. Enabling Persistent
at an interface eliminates the device detection delay that otherwise occurs.
• Macro Parameters—Displays the following fields for up to three parameters
in the macro:
- Parameter Name—Name of parameter in macro.
- Parameter Value—Current value of parameter in macro. This can be
changed here.
- Parameter Description—Description of parameter.
Click Reset to set an interface to Default if it is in Unknown status (as a result of an
unsuccessful macro application). The macro can be reapplied on the main page.
Click Apply to update the changes and assign the Smartport type to the interface.
The following describes the pair of built-in macros for each Smartport type. For
each Smartport type there is a macro to configure the interface and an anti macro
to remove the configuration.
Macro code for the following Smartport types are provided:
• desktop
• printer
• guest
• server
• host
• ip_camera
• ip_phone
• ip_phone_desktop
• switch
11
175