Cisco 300 Series Administration Manual page 389
Managed switch
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Quick start manual (72 pages) ,
- Datasheet (14 pages)
Table of Contents
Advertisement
18
STEP 1
STEP 2
352
•
Telnet—Disabled by factory default
•
SSH—Disabled by factory default
The active TCP connections are also displayed in this window.
To configure TCP/UDP services:
Click Security > TCP/UDP Services.
Enable or disable the following TCP/UDP services on the displayed services.
•
HTTP Service—Indicates whether the HTTP service is enabled or disabled.
•
HTTPS Service—Indicates whether the HTTPS service is enabled or
disabled.
•
SNMP Service—Indicates whether the SNMP service is enabled or
disabled.
•
Telnet Service—Indicates whether the Telnet service is enabled or disabled.
•
SSH Service—Indicates whether the SSH server service is enabled or
disabled.
The TCP Service Table displays the following fields for each service:
•
Service Name—Access method through which the device is offering the
TCP service.
•
Type—IP protocol the service uses.
•
Local IP Address—Local IP address through which the device is offering
the service.
•
Local Port—Local TCP port through which the device is offering the service.
•
Remote IP Address—IP address of the remote device that is requesting the
service.
•
Remote Port—TCP port of the remote device that is requesting the service.
•
State—Status of the service.
The UDP Services table displays the following information:
•
Service Name—Access method through which the device is offering the
UDP service.
•
Type—IP protocol the service uses.
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
Security
Configuring TCP/UDP Services
Advertisement
Table of Contents
