Interface Qos Settings - Cisco 300 Series Administration Manual

Quality of Service
QoS Basic Mode
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
If Override Ingress DSCP was enabled, click DSCP Override Table to
reconfigure DSCP.
DSCP In displays the DSCP value of the incoming packet that needs to be re-
marked to an alternative value.
Select the DSCP Out value to indicate the outgoing value is mapped.
Click Apply. The Running Configuration file is updated with the new DSCP values.

Interface QoS Settings

The Interface Settings page enables configuring QoS on each port of the device,
as follows:
QoS State Disabled on an Interface—All inbound traffic on the port is
mapped to the best effort queue and no classification/prioritization takes
place.
QoS State of the Port is Enabled—Port prioritize traffic on ingress is
based on the system wide configured trusted mode, which is either CoS/
802. 1 p trusted mode or DSCP trusted mode.
To enter QoS settings per interface:
Click Quality of Service > QoS Basic Mode > Interface Settings.
Select Port or LAG to display the list of ports or LAGs.
QoS State displays whether QoS is enabled on the interface.
Select an interface, and click Edit.
Select the Port or LAG interface.
Click to enable or disable QoS State for this interface.
Click Apply. The Running Configuration file is updated.
25
504