Cisco 300 Series Administration Manual page 151
Managed switch
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Quick start manual (72 pages) ,
- Datasheet (14 pages)
Table of Contents
Advertisement
9
126
-
Combo Fiber—SFP Fiber Gigabit Interface Converter Port with the
following values: 100M and 1000M (type: ComboF).
-
10G-Fiber Optics—Ports with speed of either 1G or 10G.
SFP Fiber takes precedence in Combo ports when both ports are
NOTE
being used.
•
Administrative Status—Select whether the port must be Up or Down when
the device is rebooted.
•
Operational Status—Displays whether the port is currently Up or Down. If
the port is down because of an error, the description of the error is displayed.
•
Link Status SNMP Traps—Select to enable generation of SNMP traps that
notify of changes to the link status of the port.
•
Time Range—Select to enable the time range during which the port is in Up
state. When the time range is not active, the port is in shutdown. If a time
range is configured, it is effective only when the port is administratively Up.
If a time range is not yet defined, click Edit to go to the Time Range page.
•
Time Range Name—Select the profile that specifies the time range.
•
Operational Time-Range State—Displays whether the time range is
currently active or inactive.
•
Reactivate Suspended Port—Select to reactivate a port that has been
suspended. There are numerous ways that a port can be suspended, such
as through the locked port security option, dot1x single host violation,
loopback detection, STP loopback guard or Access Control List (ACL)
configurations. The reactivate operation brings the port up without regard to
why the port was suspended.
•
Auto-Negotiation—Select to enable auto-negotiation on the port. Auto-
negotiation enables a port to advertise its transmission speed, duplex mode,
and Flow Control abilities to the port link partner.
•
Operational Auto-Negotiation—Displays the current auto-negotiation
status on the port.
•
Administrative Port Speed—Configure the speed of the port. The port
type determines which the available speeds. You can designate
Administrative Speed only when port auto-negotiation is disabled.
•
Operational Port Speed—Displays the current port speed that is the result
of negotiation.
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
Port Management
Setting Port Configuration
Advertisement
Table of Contents
