Cisco 300 Series Administration Manual page 66

Managed switch

Hide thumbs Also See for 300 Series:

Table of Contents

IP Version—Select whether an IPv4 or an IPv6 address is used.

IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The

options are:

Link Local—The IPv6 address uniquely identifies hosts on a single

network link. A link local address has a prefix of FE80, is not routable, and

can be used for communication only on the local network. Only one link

local address is supported. If a link local address exists on the interface,

this entry replaces the address in the configuration.

Global—The IPv6 address is a global Unicast IPV6 type that is visible and

reachable from other networks.

Link Local Interface—Select the link local interface (if IPv6 is used) from the

Backup Server IP Address/Name—Enter the IP address or the name of the

server to be used if no server IP address was specified in the DHCP

Backup Configuration File Name—Enter the path and file name of the file to

be used if no configuration file name was specified in the DHCP message.

Click Apply. The parameters are copied to the Running Configuration file.

Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)

Administration: File Management

Auto Configuration via DHCP