Cisco 300 Series Administration Manual page 82

Administration
Traceroute
STEP 3
STEP 4
Traceroute
STEP 1
STEP 2
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select from
where it is received.
• Destination IP Address/Name—Address or host name of the device to be
pinged. Whether this is an IP address or host name depends on the Host
Definition.
• Ping Interval—Length of time the system waits between ping packets. Ping
is repeated the number of times configured in the "Number of Pings" field,
whether the ping succeeds or not. Choose to use the default interval or
specify your own value.
• Number of Pings—The number of times the ping operation is performed.
Choose to use the default or specify your own value.
• Status—Displays whether the ping succeeded or failed.
Click Activate Ping to ping the host. The ping status appears and another
message is added to the list of messages, indicating the result of the ping
operation.
View the results of ping in the Ping Counters and Status section of the page.
Traceroute discovers the IP routes along which packets were forwarded by
sending an IP packet to the target host and back to the device. The Traceroute
page shows each hop between the device and a target host, and the round-trip
time to each such hop.
Click Administration > Traceroute.
Configure Traceroute by entering information into the following fields:
• Host Definition—Select whether hosts are identified by their IP address or
name.
5
71