Configuring Voice Vlan - Cisco 300 Series Administration Manual

VLAN Management
Voice VLAN
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 1
STEP 2
STEP 3
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
Workflow1: To configure Auto Voice VLAN:
Open the VLAN Management > Voice VLAN > Properties page.
Select the Voice VLAN ID. It cannot be set to VLAN ID 1 (this step is not required for
dynamic Voice VLAN).
Set Dynamic Voice VLAN to Enable Auto Voice VLAN.
Select the Auto Voice VLAN Activation method.
If the device is currently in Telephony OUI mode, you must disable it
NOTE
before you can configure Auto Voice Vlan
Click Apply.
Configure Smartports as described in the
Configure LLDP/CDP as described in the
CDP sections, respectively.
Enable the Smartport feature on the relevant ports using the Smartport > Interface
Settings page.
Step 7 and Step 8 are optional as they are enabled by default.
NOTE
Workflow2: To configure the Telephony OUI Method
Open the VLAN Management > Voice VLAN > Properties page. Set Dynamic Voice
VLAN to Enable Telephony OUI.
If the device is currently in Auto Voice VLAN mode, you must disable
NOTE
it before you can enable Telephony OUI.
Configure Telephony OUI in the Telephony OUI page.
Configure Telephony OUI VLAN membership for ports in the Telephony OUI
Interface page.

Configuring Voice VLAN

This section describes how to configure voice VLAN. It covers the following
topics:
Common Smartport Tasks
Configuring LLDP and
13
section.
Configuring
217