Final Ac Connections - Xantrex Truecharge TC1012 Installation Manual

Installation
5. Install the DC chassis ground (earth) from the ground
6. Connect any optional accessories. See "Installing
7. Secure cables in place using tie-wraps, P-clamps or cable
8. The DC breakers may be closed at this time.

Final AC Connections

To make the final AC connections:
1. Complete the installation by routing the AC cable to the
2. Connect the AC cable to the AC disconnect breaker and
3. Secure cables in place using tie-wraps, P-clamps or cable
4. The AC mains may be applied at this time by closing the
2–22
This guide for use by qualified installers only
stud on the Truecharge™ 2 Battery Charger to the engine
bus or DC ground bus (Figure 2-4, item 15). Use a flat
washer, a lock washer and a nut (included in the
installation kit) to secure the connection.
Tighten the nuts to 2.3 N-m (20 lb-in.) torque and test
that the wire is secure. Do not over-tighten as this may
result in damage to the charger.
Optional Accessories" on page 2–24.
straps according to electrical codes. Coil and tie any BTS
or remote panel extension cable.
AC source.
ground in accordance with the color codes on page 2–16.
straps according to electrical codes.
breaker.
975-0402-01-01