Remote Panel (Sold Separately) - Xantrex Truecharge TC1012 Installation Manual

Remote Panel (Sold Separately)

This section describes the parts of the optional remote panel
(Part number: 808-8040-00) of the Truecharge™ 2 Battery
Charger. The remote panel can be mounted using a
communications cable up to 15 m (50 ft) from the
Truecharge™ 2 Battery Charger connected via the
communication port for convenience.
Important:
means that the button must be held down for more than three
seconds then released in order to send the instruction. A "press"
action on any panel button means that the button must be pressed
and released before two seconds have elapsed.
2a
1
Figure 1-7 Truecharge™ 2 Battery Charger Remote Panel (optional)
The Remote Panel can be used to:
•
•
•
975-0402-01-01
This guide for use by qualified installers only
A "press and hold" action on any panel button
2
6a
3
Program the charger for battery type and temperature
Set the charger mode (two or three-stage charging)
Activate and terminate equalization (not allowed for
GEL and AGM)
Remote Panel (Sold Separately)
4
5
6
8
7
1–15