Configuring The Battery Bank Type - Xantrex Truecharge TC1012 Installation Manual

Configuring the Battery Bank Type

Using the Onboard Display Panel
To configure the battery bank type:
Note: By default, the battery type is set to Flooded.
1. Press and hold the Battery Type Select button for three
2. Select the proper battery type.
Using the Remote Panel
To configure the battery bank type:
Note: By default, the battery type is set to Flooded.
1. Press and hold the Status button for three seconds to enter
2. Press Set Max Output button to select the proper battery
3. Press and hold the Status button for three seconds to exit
975-0402-01-01
This guide for use by qualified installers only
Configuring the Truecharge™ 2 Battery Charger
seconds.
The LEDs will indicate which of the four types is being
selected: Flooded (default), GEL, Lead Calc., AGM.
However, if a custom battery type has been programmed
by the OEM, all four LEDs will light up to indicate a fifth
type.
the Setup mode.
Entering the Setup mode will enable you to select the
battery type.
type.
The LEDs will indicate which of the four types is being
selected: Flooded (default), GEL, Lead Calc., or AGM.
However, if a custom battery type has been programmed
by the OEM, all four LEDs will light up to indicate a fifth
type.
the Setup mode.
2–29