Configuring The Battery Temperature Without The Bts - -2-30 - Xantrex Truecharge TC1012 Installation Manual

Installation
Configuring the Battery Temperature without the
BTS
Using the Onboard Display Panel
To configure the battery temperature:
Note: By default, the Battery Temp. is set to Warm.
1. Press and hold the Battery Temperature Select button for
2. Select the appropriate battery temperature setting.
Note:
is for battery temperature between 5 and 30 °C (41 and 86 °F);
default setting. Hot is for battery temperature above 30 °C (86 °F).
See "Battery Temperature Compensation Levels" on page 2–31 to
see how output voltage is offset by varying the temperature
selection.
Using the Remote Panel
To configure the battery temperature:
Note: By default, the Battery Temp. is set to Warm.
1. Press and hold the Status button for three seconds to enter
2. Press Status button to select the appropriate battery
3. Press and hold the Status button for three seconds to exit
2–30
This guide for use by qualified installers only
three seconds.
The LEDs will indicate which of the three types is being
selected: Warm, Hot, or Cold.
Cold is for battery temperature below 5 °C (41 °F). Warm
the Setup mode.
Entering the Setup mode will enable you to select the
battery temperature setting.
temperature setting.
The LEDs will indicate which of the three types is being
selected: W(arm), H(ot), or C(old).
the Setup mode.
975-0402-01-01