Installing The Truecharge™ 2 Battery Charger; Installation Sequence - Xantrex Truecharge TC1012 Installation Manual

Installation
Installing the Truecharge™ 2 Battery
Charger
WARNING: Shock and Energy Hazards
Be sure to read the safety guidelines and pay attention to all
cautions and warnings throughout the installation procedure. The
installer is responsible for ensuring compliance with the installation
codes for your particular application.
Disconnect all sources of AC and DC power before proceeding.

Installation Sequence

To make charger installation quick and easy, Xantrex
recommends that the installation tasks be performed in the
following sequence:
1. Select charger mounting position and plan AC and DC
2. Plan DC cable runs and install fuses or breakers (page 2–
3. Plan the AC connections at the charger (page 2–15).
4. Mount the charger in position (page 2–18).
5. Make the final DC (see page 2–19) and then AC cable
6. Apply DC to the charge by closing the DC breakers or
7. Apply mains AC to the charger by closing the AC input
2–12
This guide for use by qualified installers only
cable routing.
13).
connections (including earth grounds) (page 2–19).
disconnects (page 2–23).
breaker.
975-0402-01-01