Preparing For Installation - Xantrex Truecharge TC1012 Installation Manual

Installation

Preparing for Installation

WARNING
The battery charger must be properly installed with in accordance
with all local and application-specific codes and ordinances before
it is used.
The Truecharge™ 2 Battery Charger is designed to be
permanently mounted. Figure 2-1 shows a typical installation
with three batteries, a battery temperature sensor (BTS) and a
remote panel (both optional). It also shows the AC and DC
wiring and protection devices required for a typical
installation. Means of disconnection must be incorporated
into the fixed wiring, in accordance with the electrical code
that governs each installation.
NOTE: Not to scale. For illustration purposes only.
L
N
G
1
Figure 2-1 Typical Truecharge™ 2 Battery Charger System Installation
2–2
This guide for use by qualified installers only
2
4
5
6
6
6
8
10
3
7
9
975-0402-01-01