Networking Of Iafb - Huawei iSiteC BTS3601C Installation Manual

Installation Manual
iSiteC BTS3601C CDMA Base Station

2.5.3 Networking of IAFB

I. Plan with backup power supply equipment
Figure 2-53 shows the connection between the IAFB and the BTS3601C in the
BTS3601C networking (without UPS and the IABB).
220VAC
Figure 2-53 Networking between BTS3601C and IAFB (without backup power supply equipment)
220V AC power is led into the air switch of the IAFB, then to the BTS3601C. One IAFB
can supply power for up to 3 BTS3601Cs at the same time.
Please connect the relevant cables correctly according to the labels on them, the
correspondence shown in Figure 2-54 and Figure 2-55, and the correspondence
between labels and cables shown in Table 2-3.
& Note:
1) Figure 2-55 shows the front view of cable connection on DDF shown in Figure 2-54.
2) The PGND cables of BTS3601C and other equipment in the system should all be connected to the
grounding bar on the shell of the IAFB. And a PGND cable should be led from the grounding bar on the
IAFB shell and connected to the grounding downlead of the counterpoise. This grounding cable should be
made of yellow-green plastic insulation copper wire with the core diameter not less than 35mm
IAFB
BTS3601C
BTS3601C 220VAC Input cable
The 1st pair of fiber cables or E1 cable
2-55
2 Installing Cabinet Hardware
ODU3601C
Cascading
ODU3601C 220VAC Input cable
BTS3601C 220VAC Input cable
The 2nd pair of fiber cables or E1 cable
Hardware Installation
BTS3601C
.
2