Huawei iSiteC BTS3601C Installation Manual page 93

Installation Manual
iSiteC BTS3601C CDMA Base Station
Install expansion bolts
Fix bracket
Figure 2-10 Installing the bracket
1) Position and mark the places on the wall to install expansion bolts. Figure 2-11
shows the appearance of an expansion bolt.
1) M12 expansion bolt
Figure 2-11 Positioning holes
Drill holes on the marked places via a percussion drill with the drill bit of v16, the
2)
holes should be 52mm~60mm deep and should have the same depth. After the
drilling, remove the dust inside and outside the holes with a vacuum cleaner, and
then check the distance among holes. Whenever big errors occur, the relevant
hole must be positioned and drilled again.
Mark
Drill holes
2-15
Hardware Installation
2 Installing Cabinet Hardware