Huawei iSiteC BTS3601C Installation Manual page 99

Installation Manual
iSiteC BTS3601C CDMA Base Station
1) Fix the fastener set 1 with M10 bolt onto the upper part of the holding support, then
the fastener set 2 onto the lower part of the mast or pole.
2) Adjust the spacing between the center points of two fastener sets to 378mm, as
shown in Figure 2-18.
1) Fastener set 1
Figure 2-18 Installing fastener sets
II. Installing rack
1) Align the four white washers at the rear of the rack with the four installation holes
on the fastener sets and then place the rack into the slots of two fastener sets, as
shown in Figure 2-19.
1) Hanger (at the rear of the rack)
Figure 2-19 Fixing rack with fasteners
2) Fastener set 2
2) White washer
2-21
Hardware Installation
2 Installing Cabinet Hardware