Huawei iSiteC BTS3601C Installation Manual page 104

Installation Manual
iSiteC BTS3601C CDMA Base Station
Power cable connecting to MAPM;
l
Grounding cable between cabinet and PGND bar.
l
Figure 2-25 shows the cable distribution at the bottoms of BTS3601C modules.
1) Cables connecting Type D
connectors between modules.
4) Inter-module cable between
Type N male connectors
7) MBPM E1 cable
9) MBPM optical transmission
fiber connector cable
Figure 2-25 Cable distribution at the bottom of BTS3601C
II. Cabling sequence
Waterproof measures and bottom lead-out mode is adopted during the cable
distribution of the BTS3601C. And the distribution follows the sequence inside-outside:
1) Connect Type D RF jumper between MPAM and MTRM, and fasten it with straight
screwdriver;
2) Connect Type N RF jumper between MPAM and MFEM and make waterproof
treatment for the connector via three types of tapes;
3) Connect DIN RF jumper from the antenna and feeder interface of MFEM to the
feeder and take waterproof measures for the connector via three types of tapes;
4) Connect Type N RF jumper between MFEM and MPAM and take waterproof
measures for the connector via three types of tapes;
5) Connect Type D RF jumpes respectively from MTRM to MFEM and MPAM, then
fasten them with straight screwdriver;
2) MTRM fiber cascading
connector
5) DC input power cable of
battery
8) GPS cable (Type N
connector)
10) Fiber connector connecting
MBPM to MTRM
2-26
Hardware Installation
2 Installing Cabinet Hardware
3) Antenna feeder DIN
connector connecting to feeder
6) AC power input cable