Huawei iSiteC BTS3601C Installation Manual page 86

Installation Manual
iSiteC BTS3601C CDMA Base Station
1) Top view
4) Lightning protection grounding flat steel
7) Sun-shading cover
10) Omni antenna
Figure 2-5 Installing BTS3601C on two poles
III. Note
To facilitate the introduction of power cables and trunk cables, first determine the
l
metal holding support on which the BTS3601C is to be installed. IAFB or AC
lightning protection box can be installed below the BTS3601C. The IABB can be
fixed on the platform directly. If more than 2 battery boxes are needed, a platform
should be established below the platform.
Equipment like the BTS3601C, IAFB, UPS, etc. should be installed between two
l
poles via metal parts. It is not allowed to directly install them on poles.
When feeders are used, the antenna jumpers should be bound on the crosspieces
l
of poles via cable ties. For the convenience of feeder connector preparation and
maintenance, it is prohibited to lay feeders transversely. The feeders should be
routed along the sides of the cabling rack.
If the poles are not long enough, it is recommended to connect the antenna and
l
the BTS3601C via jumper. And the jumper should be bound at the sides of the
cabling rack and on the crosspieces of poles via cable ties. Both ends of the
jumper should be grounded.
Lightning arresters should be respectively installed on two poles, and the antenna
l
of the BTS3601C should be in the protection range of the two arresters (pitch
2) Side view
5) Grounding bar
8) Holding support
11) GPS antenna
2-8
Hardware Installation
2 Installing Cabinet Hardware
3) BTS3601C
6) Soldering point
9) Lightning arrester