Huawei iSiteC BTS3601C Installation Manual page 101

Installation Manual
iSiteC BTS3601C CDMA Base Station
Start
Install MPAM
Install MFEM
Install MTRM
Install MBPM
Install MAPM
End
Figure 2-21 Module installation flow
All modules are installed as per the same process. Following is to describe the
installation process of the MPAM as an example.
1) Hold the bottom of the MPAM with the left hand, and the handle of the MPAM with
the right hand, then insert it into the position along the guide rail.
2) Tighten the M10 bolts at the upper part of the module and the two M6 fixing bolts at
the lower part alternatively for module fixation and waterproof, as shown in Figure
2-22.
1) MPAM
Figure 2-22 Installing MPAM
2-23
Hardware Installation
2 Installing Cabinet Hardware