Part Angle Measuring - Fagor Innova 20i-M Installation And Operation Manual

2.7.4

Part angle measuring

To do this, follow this procedure:
(20/40) - DRO operation - Installation/Operation - 20i-M / 30i-M - V0703
To control the part orientation angle to properly machine the part.
It calculates the angle between a particular side of the part and the horizontal
(X axis) by simply touching two points on it.
- Move the tool until it touches the part at any point.
- Access the angle calculation mode.
- Touch the part with the tool at any other point.
- Press [ENTER] so the DRO calculates the angle or [C] to cancel the
operation.
The "X" axis display will show the angle in ten-thousandths of a degree
(0.0001º) and the "Z" axis display will do so in degrees, minutes and
seconds.
-Press any key to return to the regular display mode.
T
T
Alpha