Fagor Innova 20i-M Installation And Operation Manual page 34

[Pos Nr]
[Error]
PAR20
Digit
8
7
3, 2, 1
PAR25
PAR53
Note:
PAR65
Digit
8
7
6
5
4
3
2
1
(34/40) - DRO installation - Installation/Operation - 20i-M / 30i-M - V0703
Pressing [ENTER] displays the position value (X axis display) and the amount
of error to be compensated (Y axis display).
Error to be compensated = Master's actual position - displayed position
It goes on to edit the next point.
Press this key to exit.
It sets the configuration of the axes.
Turn the feedback off after 2 minutes in "DISPLAY OFF" mode.
The displays turn off if none of the axis has moved in 30 minutes. Pressing
any key or moving any of the axes turns the displays back on.
Apply hysteresis onto the 3rd, 2nd and 1st axis respectively
Hysteresis distance desired to avoid the flickering of the displayed position
Select the number of decimals to be displayed.
Possible values:0.0 to 6.6 .
The first digit corresponds to the number of decimals to be displayed in mm
and the second digit to the number of decimals in inches.
When selecting a "0" value or a value greater than the number of decimals of
PAR01 it will display the factory set number of decimals.
It has no effect on rotary axes.
It enables various functions of the dro.
1= To enter the tool length.
1= To enter the tool diameter.
1= To compensate for tool radius.
1= To directly access parameter PAR05.
Not being used at this time. They must be set to zero.
1 = Enables the buzzer. It beeps when pressing any key.
Enables this key (linear and bolt-hole drilling, etc.)
It enables this key.