Power And Machine Connection; Installation Parameters - Fagor Innova 20i-M Installation And Operation Manual

Ready
Repeat
Error
Note:
3.5.3

Power and machine connection

3.6 Installation parameters

to
(26/40) - DRO installation - Installation/Operation - 20i-M / 30i-M - V0703
The axis status will then switch to one of the following:
Feedback configured properly.
It has set PAR00 (feedback reading direction), PAR01 (resolution), PAR03
(multiplying factor) and PAR14 (type of reference mark, I0)
Wrong feedback setup, the process should be repeated.
Error in the feedback system.
If the feedback device is a steel tape type linear encoder, press [F] before
pressing [ENTER] so it is properly detected.
Always mount it vertically so its keyboard is within operator's reach and its
digits are easily visible (at operator's eye level).
Do not connect or disconnect the DRO connectors while it is under power.
Connect all metallic parts to a common point on the machine tool and it to the
general ground point. Use cables of enough gage (no thinner than 8 mm
for this connection.
These DROs have a number of installation parameters to configure it for a
particular application.
The way these parameters are displayed depends on whether they are
general or particular for each axis.
• If it affects the axes, the parameter number (PAR??) appears on each axis
display and the corresponding axis key must be pressed to modify it.
• If it is a general parameter and there are more than one axis, the X display
will show the parameter number and the Y its current value. If there is only
one axis, its number will appear on the X display and, after pressing this
key, its value.
There are several kinds of parameters depending on how to set them:
• With binary values, it only takes values of 0 or 1 for each digit. The value is
changed by pressing the key with the relevant digit between [1] and [8].
Where [1] corresponds to the rightmost digit of the display and [8] to the
leftmost digit.
• Numeric values, usually with the corresponding axis resolution, they are
entered as regular coordinate preset.
• Options; the value is changed by pressing this key which will make the
various options appear in a cyclic way.
2
)