Execution Of Bolt-Hole Drilling - Fagor Innova 20i-M Installation And Operation Manual

To make this part:
Entering data:
RADIUS[23.918]
HOLES
ALPHA [240]
dELTA [60]
bETA [15]

2.7.1.3 Execution of bolt-hole drilling

X -23,105 Y -6,190
X 0.000 Y 0.000
HOLE 02
X 16.915 Y -16.915
X 0.000 Y 0.000
(16/40) - DRO operation - Installation/Operation - 20i-M / 30i-M - V0703
Select the work plane selection. See section 2.7.1.1 Work plane selection:.
- Position the tool at the bolt-hole center (X = 37.899, Y = 30.467) and press
this key.
- Enter the radius.
- Enter the number of holes.
- Enter the angular distance between the first and last holes.
When entering "0" holes, enter the angular distance between holes.
- Enter the angle of the first hole.
If a wrong value were keyed in before pressing [ENTER], press [CLEAR]
and key in the right value.
After entering this data, the DRO displays the text "HOLE 01" in the display
"X" and turns the "Y" off.
- After pressing this key to---
- ... show the position of the first hole:
- Move the axes until the displays read X 0.000 and Y 0.000
- Press this key
- It displays this text.
- Press this key again to---
... show the position of the second hole.
- Press this key to display the current position with respect to the previous
hole.
- Move the axes until the displays read X 0.000 and Y 0.000
And so on until all the holes are completed (all 5 in the example).