Incremental Mode - Fagor Innova 20i-M Installation And Operation Manual

2.2.1.2 Incremental mode

"ABS" off
First method:
(B) [14.000]
(C) [23,000]
(D) [25,000]
Note:
Second method:
-14
(B) [0.000]
-23
(C) 0.000
-25
(D) [0.000]
Notes:
(8/40) - DRO operation - Installation/Operation - 20i-M / 30i-M - V0703
Set the dro in incremental mode. ABS LED off
Presetting incremental zero after each drill.
Starting at point A.
Move the axis until the display reads [14.000] (B position) and drill the hole.
Set the X axis to zero. See note.
Move the axis until the display reads [23,000] (C position) and drill the hole.
Sets the X axis to zero. See note.
Move the axis until the display reads [25,000] (D position) and drill the hole.
If installation parameter PAR11=1, just press the axis key, ([X]) in this case, to
zero the axis.
Presetting the relative distance with respect to the next hole.
Starting at point A
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (B position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (C position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (D position) and drill the hole.
If installation parameter PAR11=1, the presetting sequence is: [ENTER] [axis]
[value] [ENTER].
Switching over to [ABS] mode, displays the distance to part zero (datum).
The calculator function can also be used to preset an axis with the result of
the calculation. See section 2.7.3 Calculator.