Operation Of The Cnc As A Readout; Change Of Measuring Units; Cnc Reset - Fagor 8025 T CNC Operating Manual

3.5.7. Operation of the CNC as a readout

Once the JOG operating mode is selected, if the external MANUAL input is activated, the
CNC acts as a readout. In this case, the machine has to be moved by means of external
controls and the analog signals must be generated outside the CNC.The S and M functions
may be entered in this form of operation. If when operating in this mode, the software
travel limits (set via machine-parameters) are overrun, the CNC will send the relevant
error code and will only allow the machine to be moved to bring it back to the permitted
zone.

3.5.8. Change of measuring units

Every time the key I is pressed the measuring units change from mm to inches and vice-
versa.

3.5.9. CNC Reset

Once the JOG mode is selected, when is pressed, the CNC returns to the initial
conditions.
8025/8030 CNC OPERATING MANUAL 35