Fagor Innova 20i-M Installation And Operation Manual page 27

To get into parameter editing
CODE: 060496
Note:
To enter a parameter
[Value]
Move through parameters
To quit the parameter editing mode:
To go to a particular parameter:
PAR Nr
To recover the factory set default values for the installation parameters:
The dro displays must be on, reading mode and press the following keys:
The X axis display shows the word " COdE ". 060496
The displays of the DRO show PAR00.
Once in regular display mode, parameter PAR05 (scaling factor) may also
be recalled by pressing this keystroke sequence, so the work mode may be
changed without having to go through all the previous steps.
Like PAR05, parameter PAR53 is directly accessible.
• Select axis.
• Press this key to save the displayed value.
• Press this key to cancel the modification.
Press the [ENTER] key to go on to the next parameter or ---
Press this key to return to the previous one.
Press this key.
To go directly to a particular parameter without going through the previous
ones, (once in parameter editing mode) press this key sequence.
Then, select the axis affecting this parameter.
Once in parameter editing mode, displaying PAR00 on all the displays,
press this keystroke sequence. The dots of the first axis will light up.
V0703-20i-M / 30i-M - Installation/Operation - DRO installation - (27/40)