Special Functions; Angle Measurement; Turning Function - Fagor Innova 40i Installation And Operation Manual

3.3

Special functions

Function
It gives access to the specific lathe functions.
3.3.1

Angle measurement

Function
Angle measurement
It may be used to calculate the angle or taper of a part by
touching two points.
Touch the first point and press Enter.
Touch the second point and press Enter.
It shows the calculated angle in degrees and degrees -
minutes - seconds.
3.3.2

Turning function

Function
Turning
Assistant for defining a turning cycle after having entered the
following data:
X: Starting diameter. Move the X axis until the tool touches the
part. Press X axis button to enter the position value on the X
axis. If the part diameter is known, its value may be entered
directly. Press Enter. The next field (box) is activated.
Z: Initial Z axis value. Place the tool touching the part on the Z
axis. Preset a value and press the button for the Z axis to enter
the value of the Z axis display. Press Enter. The next field (box)
is activated.
X: Enter final diameter. Press Enter.
Z: Enter Z axis final value. Press Enter. Press Enter.
Cut: Enter cutting pass in mm. The DRO will use this value also as the safety distance to withdraw after
each pass.
Execute turning cycle. Move the axes until both axis displays read zero.
Run
Go on to the next execution step.
Total number of steps.
Current step Nr.
40i - Installation/Operation - DRO operation - (19/40)