Table of Contents
Advertisement
4.3 EDIT A NEW PART-PROGRAM
To edit a new part-program the following steps should be taken:
* Press
* Use the pointer to select the option "--Create new part --2" in the left-hand column.
* Press
program, prompting the first one available.
* Type in the program number required and press
This must be a number between 1 and 899999, and both numbers can be used.
* The CNC will ask for the comment to be assigned to the part-program.
A comment does not have to be associated.
* Press
The CNC includes the new part-program in the list of part-programs (left-hand column).
From this time all the operations required can be stored, and in the required order.
4.3.1
STORAGE OF AN ISO BLOCK OR A CYCLE
An ISO block or a cycle may be added at the end of the program, after the last operation, or inserted
between 2 existing operations.
To store an operation the following steps must be taken:
* Define the operation or cycle required, assigning this the relevant data
* Press
* Use the pointer to select the program number required in the left-hand column and go on to
the right-hand column.
* Move over the operation after which the block or cycle is to be stored and press
Example:
4.- User cycle 3
7.- User cycle 9
Chapter 4 - page 4
to access the list of part-programs stored.
. The CNC will ask at the bottom for the number to be given to the new part-
or
to access the list of part-programs stored.
You have
1.- User cycle 2
2.- User cycle 5
3.- User cycle 11
4.- User cycle 1
5.- User cycle 8
After defining the cycle move over the operation "3.- User cycle 11"
and press [Enter]
After defining the cycle move over the last operation "User cycle 8"
and press [Enter]
MCO-TCO work mode
You want
1.- User cycle 2
2.- User cycle 5
3.- User cycle 11
4.- User cycle 3
5.- User cycle 1
6.- User cycle 8
7.- User cycle 9
Advertisement
Table of Contents
