Operating With Tools; Entering Tool Dimensions; Tool Dimension Compensation While Machining; Datum Point (Part Zero) To Work With Tool Compensation - Fagor Innova 20i-M Installation And Operation Manual

2.4 Operating with tools

2.4.1

Entering tool dimensions

[Value]
Note:
2.4.2

Tool dimension compensation while machining

Tool
2.4.3

Datum point (part zero) to work with tool compensation

ABS
(10/40) - DRO operation - Installation/Operation - 20i-M / 30i-M - V0703
It is possible to define a tool and later compensate for its dimensions while
machining.
The Y axis blinks waiting for the tool value to be entered.
20i-M.- It requests the tool diameter.
30i-M.- It requests the diameter on the Y axis and the length on the Z axis.
Enter this value pressing this keystroke sequence.
Since only the diameter of a tool may be stored, when changing a tool, its
dimensions must be entered again.
To properly machine the part, the tool diameter must be compensated
depending on the machining direction.
This led turns on when activating any of the compensations.
Cancels tool compensation and turns the Tool led off.
Set the dro in absolute mode.
Move the tool and touch the side of the part, activate the corresponding
compensation and set the axis to zero.
Z
Y
X