Special Operations; Scaling Factor - Fagor Innova 20i-M Installation And Operation Manual

Notes:

2.5 Special operations

2.5.1

Scaling factor

X
In the example of the figure, the sequence would be:
For the X axis, move the tool and touch it on the left side and press this key.
To preset this side to "0". See note.
For the Y axis, move the tool and touch it on the lower side and press this key.
To preset this side to "0". See note.
If installation parameter PAR11=1, just press the axis key, [X] [Y] or [Z], to
zero it.
The tool diameter value must be previous entered in order to set the datum
(zero) point correctly.
It is possible to apply a scaling factor within ±9.999 for mold making
applications:
The DRO will then show the axis position resulting from multiplying its real
position by the 'value' of the scaling factor.
V0703 - 20i-M / 30i-M - Installation/Operation - DRO operation - (11/40)
[factor]
Y