Table of Contents
Advertisement
2.4 Operating with tools
2.4.1
Entering tool length
[Value]
Note:
2.4.2
Absolute and incremental mode
(8/29) - DRO operation - Installation/Operation - 10i / 20i - V0703
It is possible to define a tool and later compensate for its length while
machining.
The Y axis blinks waiting for the tool value to be entered.
It requests the tool length.
Enter this value pressing this keystroke sequence.
Since only the length of a tool may be stored, when changing a tool, its length
must be entered again.
We will drill the holes of the following part as moving examples in incremental
and absolute modes.
A
B
C
D
Advertisement
Table of Contents
