Active-Tools Table - Fagor CNC 8070 Operating Manual

Operating manual
9.4
9.
CNC 8070
(S V03.0 )
OFT X
190

Active-tools table

This table shows the list of available tools and which one is active in each channel.
The table is divided in two panels. To switch panels, press the panel-change key.
A
(A) Tool listing.
(B) Active tools.
(C) Tool selected on the list.
The left panel shows the list of the available tools and the right panel shows the data
of the active tool in each channel.
Tool listing
For each tool, it indicates the position and the magazine where it is located, whether
it is a ground tool or the tool is active in a channel. The CNC updates data of the list
every time a tool change is carried out.
It is the same list that appears in the tool table. See
Active tools
It shows the data of the active tool in each channel and also the data of the tool
selected on the list. It is also possible to change the tool of the spindle. See
"9.4.1 Changing the tool of the spindle"
The tool data cannot be edited on this screen. The data shown here is defined in the
tool table.
"9.2.2 The tool list" on page 180.
on page 191.
B
C