User manual 1 Safety Precautions This appliance can be used in public areas. Remove all objects from pockets such as lighters and matches. WARNING. This appliance is intended only for drying textiles washed in water. DO NOT MODIFY THIS APPLIANCE. Servicing shall be carried out only by authorized personnel.
• replacement of light bulbs, filters or any consumable parts; • any accessories and software not approved or specified by Electrolux Professional. Warranty does not include scheduled maintenance activities (including the parts required for it) or the supply of cleaning agents unless specifically covered within any local agree- ment, subject to local terms and conditions.
User manual 4 Operation 4.1 Controls fig.W01423 Release Stop Forward The ironer is controlled via the movable gate in front of the cylinders (A) and the ON/OFF switch (B). The gate has three positions: 1. Release 2. Stop 3. Forward The gate also proves contact against contact.
User manual For thick items If an item is too thick, the ironer will stop and the red LED below the ON/OFF switch will light up. Release and pull out the item. Resume ironing with smaller items. The ironer cloth may be damp. You should therefore always leave the ironer with the ironer cloth full pulled out. 4.2 Motor guard fig.W01424 The ironer is equipped with overheat protection to protect the ironer’s electrical compo-...
Page 12
User manual Short items Pillowcases, towels and the like are ironed inside the ironer cloth. It is important to pull the entire ironer cloth out first. (Otherwise a pocket could form behind the cylinder). Then run forward about one turn before adding the item. Do not place anything inside the read seam of the ironer cloth.
User manual 5 Servicing Before contacting the service department, you should find out the name, article number and serial number of the ironer. This information is found on the identification plate. fig.W01426...
User manual 6 Disposal information 6.1 Disposal of appliance at end of life Before disposing of the machine, make sure to carefully check its physical condition, and in particular any parts of the structure that can give or break during scrapping. The machine’s parts must be disposed of in a differentiated way, according to their different characteristics (e.g.
Page 16
Electrolux Professional AB 341 80 Ljungby, Sweden www.electroluxprofessional.com...
Need help?
Do you have a question about the CI6-80 and is the answer not in the manual?
Questions and answers