Panasonic KX-TDE100 Features Manual page 376

1.30 Networking Features
• The monitor PBX stops receiving status information for the selected extension. All NDSS
buttons for that extension stop displaying status information.
However, the related information is not deleted from the Network Monitor Extensions Table. Therefore,
if an extension user at a monitor PBX subsequently goes off-hook and presses the NDSS button for
that extension, monitoring will be reactivated. To completely remove monitoring of an extension, the
registration data must also be deleted from the Network Monitor Extensions Table at each monitor PBX.
The monitor destination of each NDSS button is determined by the registration information for a
particular index number in this table. Therefore, if the registration information for an index number is
changed (for example, the Network Extension Number assigned to Index No. 001 in the example above
is changed from "2001" to "4002"), any NDSS buttons that have been set for that extension will
automatically point to the new monitor destination.
Conditions
• The KX-NCS4910 (Activation Key for Software Upgrade to Enhanced Version) is required for all KX-
TDE series PBXs that will monitor extensions or have extensions monitored.
• Hardware Requirements:
If using an IP-GW4E card (KX-TDA0484), the firmware (not LPR) of the card must be version 1.2 or
later. If using a PRI23 card (KX-TDA0290), the LPR software of the card must be version 1.009 or later.
• All PBXs in the network must be KX-TDE or KX-TDA series PBXs. For information on the hardware
requirements for KX-TDA series PBXs that will monitor extensions or have extensions monitored, refer
to the KX-TDA Feature Guide.
• Each of Network PBX IDs 1-8 can only be assigned to one PBX within a network. Assigning the same
Network PBX ID to two PBXs will cause network data transmission problems.
• It is only possible to assign NDSS buttons for extensions that have been previously registered in the
Network Monitor Extensions Table.
2.10.5 [4-1-4] Wired Extension—Flexible Button
→ Type
→ Dial (for NDSS)
2.10.13 [4-2-3] Portable Station—Flexible Button
→ Type
→ Dial (for NDSS)
2.10.17 [4-3] DSS Console—Flexible Button
→ Type
→ Dial (for NDSS)
• Extensions connected to one PBX can monitor a maximum of 250 extensions at other PBXs. One
extension can be monitored by multiple extensions at multiple PBXs.
• To reduce NDSS data traffic, it is recommended that 8 or less extensions in a single Incoming Call
Distribution Group be monitored.
• Activation of an NDSS button is only required the first time that a button for a newly registered extension
is created. Once an NDSS button has been activated by being pressed the first time, any further NDSS
buttons for the same monitored extension will automatically display the extension status without
needing to be activated.
• To use the NDSS Monitor Release feature, an extension must be assigned as a manager.
→ 2.8.12 [2-7-1] Class of Service—COS Settings—Extension Feature—Manager
→ [511] Manager Assignment
• A maximum of two ports of each BRI card can be assigned to transmit extension status information
("ON").
• Through system programming, it is possible to assign a maximum number of "hops" (transfers between
PBXs) that extension status information can travel. Each time a piece of extension status information
is forwarded to another PBX, its counter is increased by one. When this counter reaches the assigned
376 Feature Guide