FENDT varioguide Operator's Manual page 97

Set correction signal
Select the correction signal via the "Signal
1.
Type" selection field.
Select 'Internal Modem' as the modem type
2.
Select "Dial connection (GSM)" or "Data
3.
connection" as the connection type
Select signal format
4.
Display
Satellite receiver
Signal type
Modem type
Connection type
Signal strength
Accuracy
Signal lag
Connection status
Authorisation level
Signal format
VarioGuide
438.020.070.012
Designation of the installed receiver
The correction signal source can be selected here
Internal modem
Dial connection (GSM) / Data connection
Mobile communications signal strength
Bar indicator and decimal value of static accuracy
Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
from the correction signal provider
Fig. 45
7. Start-up
97