Rangepoint Rtx - FENDT varioguide Operator's Manual

7. Start-up

7.8.3 RangePoint RTX

Set correction signal
Select the correction signal via the "Signal
1.
Type" selection field.
Set the frequency.
2.
Select the service ID.
3.
Select the baud rate.
4.
Display
Satellite receiver
Frequency
Baud rate
Accuracy
Signal lag
Connection status
Authorisation level
Serial no.
Expiry date
102
Designation of the installed receiver
Bar indicator and decimal value of static accuracy
Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
Trimble AG-382 serial number (6-digit)
Expiration date for RangePoint RTX license
Fig. 50
VarioGuide
438.020.070.012