FENDT varioguide Operator's Manual page 148

8. Faults and remedy
Fault
Poor reception of
OmniSTAR correction
signal.
148
Possible cause:
No OmniSTAR correction
signal is present in the
operating region of the
tractor.
Correction signal satellite
is not visible.
OmniSTAR has not sent
full data for correction
signal / license.
The correction signal has
been set incorrectly at
the terminal.
Incorrect receiver serial
number transmitted to
OmniSTAR.
Indication
more are displayed on
the flat.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1
Check
system info/system
status, page 125.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1
Check
system info/system
status, page 125.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status, page 125.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status, page 125.
Remedy
Inform OmniSTAR of the
tractor's operating
region.
<xref href="#T003398"/
>.
Contact your FENDT
dealer.
Set proper correction
signal.
Send OmniSTAR correct
receiver serial number.
VarioGuide
438.020.070.012