Configure The Fendt Base Station Correction Signal (Trimble 900 Mhz) - FENDT varioguide Operator's Manual

7. Start-up
Display
Mode
Frequency
Signal format

7.10.1.2 Configure the FENDT base station correction signal (Trimble 900 MHz)

Procedure
Select the correction signal via the "Signal
1.
Type" selection field.
NOTE:
Correction signal activation can only be
received if a green tick appears in the
connection status. Where applicable, verify
channel, frequency and signal format.
Select 'Fendt Station' under station type
2.
Set the network ID
3.
Display
Satellite receiver
Signal type
Base Type
Accuracy
Signal lag
Connection status
Authorisation level
106
Set here: TT450s 4800 bps or TT450s 9600bps
Set the frequency assigned to you by your country's regulatory authority.
The signal format is displayed
Designation of the installed receiver
The correction signal source can be selected here
Fendt Base
Bar indicator and decimal value of static accuracy
Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
Fig. 54
VarioGuide
438.020.070.012