Figure 4-18: Viewing Gps Coordinates In Comm-Set Screen - 3M SP-SE-2-1/1 User Manual

Sound level meter. soundpro se series; soundpro dl series
Table of Contents

Advertisement

55
Communications
GPS
 Enabling GPS communications
1. If a session is running, stop it.
2. Connect the RS-232 cable to the GPS receiver and to the auxiliary
3. Referring to the user manual for the GPS receiver, prepare the device
4. In the SoundPro SE/DL Setup screen, press the arrow keys to
5. Press the down arrow to highlight "RS-232".
6. Repeatedly press
 NOTES: If you are not using RS-232 communications in any way, you
should keep the RS-232 channel set to the Off/Lo-Pwr setting.
Status line - This data field at the right on this line tells you whether GPS is
enabled or not. You may see "No Fix" below this line, which tells you that,
although enabled, the instrument is not receiving the satellite signal.
Position line - When the satellite signal is being received, there will be two
data fields on this line that give the instrument's latitude (N or S) and
longitude (E or W) position in degrees and minutes.
Other line - When the satellite signal is being received, there will be two
data fields on this line that give the instrument's altitude and time, in that
order. The altitude is given in meters above mean sea level. The time is
given for Greenwich, England (GMT) and differs in hours from your time by
the number of time zones between your location and Greenwich.
port of the SoundPro SE/DL instrument ("Auxiliary port" on page 7).
to receive satellite signals.
select Comm-Set, then press
appears.

Figure 4-18: Viewing GPS coordinates in COMM-Set screen

at 4800 unless otherwise specified by your GPS manufacturer.
, and the Comm-Set screen
until "GPS" is displayed. The Baud rate should be kept
Viewing GPS coordinates
Models SE and DL

Advertisement

Table of Contents
loading

Table of Contents