Qsp/Serial; Mass Storage - 3M SP-SE-2-1/1 User Manual

Sound level meter. soundpro se series; soundpro dl series

Table of Contents

Communications

QSP/Serial

(Figure 4-14). For QSP-II communications, USB should be set to

"QSP/Serial". The RS-232 channel should be turned off for low power

consumption.

When the USB channel is set for Mass Storage mode the user will have direct

access to the instruments SD card through programs such as "Windows file

manager". Much the same way a small pocket USB flash drive operates. When

obtaining data from the SoundPro via Mass Storage, it is important to remember

that the data obtained is in Native SoundPro SES format (It cannot be read with

Excel, Word, etc.) A SoundPro SES to XML conversion utility is available.



NOTE: When using Mass storage, the user must use the Windows "Safely Remove

Hardware" feature to un-mount the SoundPro from the PC in the same manner a

user must remove a flash drive. This "Windows" feature is usually found in the lower

right-hand side of the windows systems tray.

Figure 4-14: QSP/Serial

Figure 4-15: Mass Storage

Models SE and DL

Table of Contents

Sp-se-1 Sp-se-2-1/3 Sp-se-1-1/1 Sp-se-2 Sp-se-1-1/3 Sp-dl-2-1/1 ... Show all