Viewing Real-Time Measurements Remotely; Log To Port - 3M SP-SE-2-1/1 User Manual

53 Communications

Viewing real-time measurements remotely

 USB communications
1.
2.
3.
4.
5.
6. Press
7. Connect the small end of the USB cable to the USB port ("Hardware
8. Connect the large end of the USB cable to a standard-sized USB connector
Viewing real-time measurements remotely
On the SoundPro, the "Log to Port" feature, provides the functionality to stream
logged data out the serial port at the log rate to an external device (such as a pc).
With this feature, you are able to view logged measurements for broadband as
well as filter band average measurements (depending on the model you
ordered). It will not report Lmax, Lmin, or Lpk for each filter band.
 Turning on log to port
1. In the Comm Set screen (selectable via the Set-up screen), select RS-232
2. Press
If a session is running, stop it.
In the Start screen, press
screen appears.
In the Setup screen, press the arrow keys to select Comm Set, then press
and the Comm-Set screen appears.
USB should be Highlighted. Press
"Mass Storage".
If the RS-232 channel is not set to "Off/Lo-Pwr", press the left arrow to
highlight RS-232 and repeatedly press
to exit the screen.
interfaces" on page 6).
on the computer.
field (by pressing the down arrow).
repeatedly to turn on LOG PRN.
Figure 4-16: Log to Port
to select Setup, then press
to toggle between "QSP/Serial" and
until Off/Lo-Pwr is displayed.

LOG to Port

Press Enter key repeatedly
to activate
. The Setup
Models SE and DL