13
Microphone and accessories
Class/Type 1 and Class/Type 2 instrument
Class/Type 1 and Class/Type 2 instrument
The SoundPro is shipped with the Type 1 in a protective case with a serial number
labeled on the side of the microphone. Similarly, the SoundPro with the Class/Type 2
microphone is also shipped in a protective case. To attach and remove the
microphone, please follow one of the types below:
•
•
•
Windscreen
Use a windscreen that fits the tip of the microphone to reduce sound disturbances
caused by physical contact and wind turbulence. 3M provides the WS-7
windscreen that fits a ½-inch microphone with every instrument kit. If you didn't
order a ½-inch microphone, or if you have one of different size, you may wish to
order a windscreen for the other size.
BK4936 microphone - Remove the microphone from its case and thread it on the
SoundPro SE/DL preamp in accordance with the instructions provided in the
microphone case. Note that the BK4936 microphone is provided with a Random
Incidence Corrector (RIC). Use the same microphone instructions for information
about using and installing that device.
All other Class/Type 1 microphones -
protective case and thread it on the preamp. Before using, be sure to remove the
plastic cap and save it in the case for future use.
Class/Type 2 microphones
microphone from its protective case and thread it on
the preamp. Before using, be sure to remove plastic
cap and save it in the case for future use.
NOTE: to properly remove the microphone, please
adhere to the caution sticker located on the backside of
the instrument and the drawing to the right.
Figure 2-3: SoundPro with microphone and windscreen
Remove the microphone from its
Remove the
–
No
Yes
Models SE and DL