Logging; Logging Options; Exceedance Level; Filters - 3M SP-SE-2-1/1 User Manual

Sound level meter. soundpro se series; soundpro dl series

Table of Contents

Logging

Logging

Logging options

If the logging option was

purchased, you will have the

following four types of

measurement options:

•



Up to two different exceedance level percentages, ranging from 1-99, can be

set in the Meter 1 Logging screen when the logging interval is set to 1

minute.



NOTE: if the logging interval field is not set to 1 minute, "N/A" (not

The filter option is either a "On" or "Off" setting in Meter 1 and is only

available if the instrument contains a filter option.  NOTE: The filter option

must be set to "on" to data log filtered data.

The logging interval is the length of time between logging events.

 NOTE: The inverse of the logging interval is the logging rate.

Average (AVG on the display), Peak, Maximum (MAX on the display),

Minimum (MIN on the display).

NOTE: When logging is enabled and you are viewing these

measurements on the SoundPro display, these are labeled as: L_avg (or

L_eq if the exchange rate is set to 3 dB), L_Pk, L_Mx and L_Mn,

respectively (See Chapter 5, "Preparing to measure and running".)

available) will appear in the data field.

Figure 3-7: Logged Data Chart example

Models SE and DL

Table of Contents

Sp-se-1 Sp-se-2-1/3 Sp-se-1-1/1 Sp-se-2 Sp-se-1-1/3 Sp-dl-2-1/1 ... Show all