KEB COMBIVERT F5 series Installation Manual & Operation Manual page 32

Special Adjustments
Relay output 1
Relay output 2
32
CP.31 and CP.32 determine the function of the two outputs.
CP.31 for relay output 1 (terminal X2A.24...X2A.26)
CP.32 for relay output 2 (terminal X2A.27...X2A.29)
The switching level of CP.32 is CP.33!
Value Function
0 No function
1 On; active when unit has voltage applied to it
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (no auto-reset)
6 Warning or error message at abnormal stopping
7 Overload alert signal
8 Overtemperature alert signal power modules
9 External Overtemperature alert signal motor
10 Motor thermal relay tripped (OH2)
11 Overtemperature alert signal interior (OHI)
12 Cable breakage on analog input 1 (4...20 mA)
13 Cable breakage on analog input 2 (4...20 mA) {F5G only}
14 Max. constant current (stall, CP.25) exceeded
15 Max. ramp current (LA-Stop CP.24) exceeded
16 DC-braking active
17 Power off
18 Motor brake control
19 PID control difference > switching level {F5G only}
20 Actual value= set value (CP.3= Fcon, rcon; not at noP, LS
error,SSF)
21 Accelerate (CP.3 = FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Actual load utilization (CP.6) > 100%
25 Active current > switching level
26 Actual DC voltage (CP.7)>switching level
27 Actual frequency (CP.1) > switching level
28 Set frequency (CP.2) > switching level
29 Ref. point run complete {F5G only}
30 Actual torque > level {F5G only}
31 Absolute speed on AN1 > switching level
32 Absolute speed on AN2 > switching level {F5G only}
33 Absolute. speed on AN3 > switching level {F5G only}
34 Set value on AN1 > switching level
35 Set value on AN2 > switching level {F5G only}