KEB COMBIVERT F5 series Installation Manual & Operation Manual page 40

Error Diagnosis
E.CO1 ERROR counter overrun 1
E.CO2 ERROR counter overrun 2
E. BR ERROR brake
E.INI ERROR initialization MFC
E.HYBc ERROR hybrid changed
E.ccd ERROR calculation drive
E.OS ERROR over speed
A.OHI ABN.STOP overheat int.
A.nOH no A. overheat pow.mod.
A. OH A.STOP overheat pow.mod
A. EF ABN.STOP external fault
A.ndOH no A. drive overheat
A.nOHI no A.STOP overheat int.
A.buS ABN.STOP bus
A.PRF ABN.STOP prot. rot. for.
A.PRR ABN.STOP prot. rot. rev.
A.dOH ABN.STOP drive over heat
A.OH2 ABN.STOP motor protect.
A.nOL no ABN.STOP overload
A. OL ABN.STOP overload
A.OL2 ABN.STOP overload 2
A.nOL2 no ABN.STOP overload 2
A.SET ABN.STOP set
40
54 Error: Counter overflow encoder channel 1
55 Error: Counter overflow encoder channel 2
56 Error: This error can occur in the case of switched on brake cont-
rol, if the load is below the minimum load level Pn.58 (application
mode) at start up.
57 Error: MFC not booted
59 Error: Encoder interface identifier has changed, it must be confir-
med over ec.0 or ec.10 (application mode).
60 Error: during the automatic motor stator resistance measurement
105 Error: Real frequency is bigger than the max. Output frequency
87 Warning: overtemperature in the interior
88 Warning: no more overtemperature of power module
89 Warning: Overtemperature of power module
90 Warning: external error
91 Warning: no more overtemperature of motor TEMPERATURE
SENSOR. Motor SENSOR is low-resistance again.
92 Warning: no more overtemperature in the interior
93 Warning: Watchdog for communication between operator/control
card has responded
94 Warning: locked direction of rotation clockwise
95 Warning: locked direction of rotation counterclockwise
96 Warning: overtemperature of motor TEMPERATURE SENSOR
97 Warning: electronic motor protective relay has tripped
98 Warning: no more overload, OL counter has reached 0 %.
99 Warning: Overload can only be reset at A.nOL, if OL counter has
again reached 0 %
100 Warning: Overload can only be reset at A.nOL2, if cool-down time
has elapsed
101 Warning: no more overload, the cool-down time has elapsed.
102 Warning: set selection: It has been attempted to select a locked
parameter set.