Table of Contents
Advertisement
4.12
STP Configuration
The Spanning Tree Protocol (STP) is a standardized method (IEEE 802.1D) for
avoiding loops in switched networks. When STP is enabled, ensure that only
one path is active between any two nodes on the network at a time. User can
enable Spanning Tree Protocol on switch's web management and then set up
other advanced items. We recommend that you enable STP on all switches to
ensure a single active path on the network.
STP Status
4.12.1
Function name: STP Status
Function Description: In the Spanning Tree Status, user can read 12 para-
meters to know STP current status. The 12 parameters' description is listed
in the following table.
Parameter Description:
STP State: Show the current STP Enabled / Disabled status. Default is
"Disabled".
Bridge ID: Show switch's bridge ID which stands for the MAC address
of this switch.
Bridge Priority: Show this switch's current bridge priority setting.
Default is 32768.
Designated Root: Show root bridge ID of this network segment. If this
switch is a root bridge, the "Designated Root" will show this switch's
bridge ID.
Designated Priority: Show the current root bridge priority.
Root Port: Show port number connected to root bridge with the
lowest path cost.
Root Path Cost: Show the path cost between the root port and the
designated port of the root bridge.
LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 4: Operation of Web- based Management
77
Advertisement
Table of Contents
