Leds And Buttons On The Lancom Es-2126P - Lancom ES-2126+ Manual

LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 2: Installation
»
PWR Power LED: Constant green when power is supplied to the device.
¿
ACT Constant green when the LED mode is set to "Active".
´
Constant green when the LED mode is set to "Full-Duplex".
FDX
²
SPD Constant green when the LED mode is set to "Speed".
¶
LEDSET Button to switch the LEDmode between -"Active", "Full-Duplex" and "Speed".
º
LINK Constant green when the network connection is established to the connected
Port 1 to 24
device. Off if no network connection can be established to the connected
device.
¾
ACT/FDX/SPD This LED displays the following information depending on the selected LED
Port 1 to 24
status:
µ
Constant green when the network connection is established to the connected
Link
Port 25 and 26
device. Off if no network connection can be established to the connected
device.
¸
FB Constant green when the optical port is active. Off when the TP port is active
Port 25 and 26
¹
This LED displays the following information depending on the selected LED
ACT
Port 25 and 26
status:
2.3.2

LEDs and buttons on the LANCOM ES-2126P

Located on the front of the device are light-emitting diodes (LEDs) that pro-
vide information on device status, and also two buttons.
16
LED mode "Active": Blinks yellow during data transfer.
LED mode "Full-Duplex": Constant green when full-duplex mode is active
for this port; blinks yellow in case of collisions.
LED mode "Speed": Constant yellow when the 100 Mbps mode is active.
Off when the 10 Mbps mode is active.
LED mode "Active": Blinks yellow during data transfer.
LED mode "Full-Duplex": Constant green when full-duplex mode is active
for this port; blinks yellow in case of collisions.
LED mode "Speed": Constant green when the Gbps mode is active. Off
when the 10 Mbps or 100 Mbps mode is active.