Table of Contents
Advertisement
LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 4: Operation of Web- based Management
Media type
NWay
100M TP
ON/OFF
1000M TP
ON/OFF
1000M Fiber
ON/OFF
46
Function Description: It is used to set each port's operation mode. The
switch supports 3 parameters for each port. They are State, Speed/Duplex
and Flow Control.
Parameter Description:
State: Set the communication capability of the port is Enabled or
Disabled. When enabled, traffic can be transmitted and received via
this port. When disabled, the port is blocked and no traffic can be
transferred through this port. Port State is configurable by the user.
There are only two states "Enable" and "Disable" able to choose. If
you set a port's state "Disable", then that port is prohibited to pass
any traffic, even it looks Link up.
Default: Enable.
Speed/Duplex: Set the speed and duplex of the port. In speed, 10/
100Mbps baud rate is available for Fast Ethernet, Gigabit module in
port 25, 26. If the media is 1Gbps fiber, it is always 1000Mbps and
the duplex is full only. If the media is TP, the Speed/Duplex is compri-
sed of the combination of speed mode, 10/100/1000Mbps, and dup-
lex mode, full duplex and half duplex. The following table summarized
the function the media supports.
Speed
10/100M
10/100/1000M
1000M
In Auto-negotiation mode, no default value. In Forced mode, default
value depends on your setting.
Flow Control: There are two modes to choose in flow control, inclu-
ding Symmetric and Asymmetric. If flow control is set Symmetric, both
parties can send PAUSE frame to the transmitting device(s) if the
receiving port is too busy to handle. When it is set Asymmetric, this
will let the receiving port care the PAUSE frame from transmitting
device(s), but it doesn't send PAUSE frame. This is one-way flow con-
trol.
Default: Symmetric.
Duplex
Full/Half
Full for all, Half for 10/100
Full
Advertisement
Table of Contents
