Table of Contents
Advertisement
LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 5: Operation of CLI Management
5 Operation of CLI Management
5.1
CLI Management
Refer to Chapter 2 for basic installation. The following description is the brief
of the network connection.
Baud rate
Stop bits
Data bits
Parity
Flow control
5.1.1
Login
126
-- Locate the correct DB-9 null modem cable with female DB-9 connector.
Null modem cable comes with the management switch. Refer to the
Appendix B for null modem cable configuration.
-- Attach the DB-9 female connector to the male DB-9 serial port
connector on the Management board.
-- Attach the other end of the DB-9 cable to an ASCII terminal emulator
or PC Com-1, 2 port. For example, PC runs Microsoft Windows
HyperTerminal utility.
-- At "Com Port Properties" Menu, configure the parameters as below:
(see the next section)
The command-line interface (CLI) is a text-based interface. User can
access the CLI through either a direct serial connection to the device or a
Telnet session. The default values of the managed switch are listed below:
Username: admin
Password: admin
After you login successfully, the prompt will be shown as "#" if you are the
first login person and your authorization is administrator; otherwise it may
show "$". See the following two figures. The former means you behave as
an administrator and have the access right of the system. As to the latter,
it means you behave as a guest and are only allowed to view the system
without the permission to do any setting for this switch.
57600
1
8
N
none
Advertisement
Table of Contents
